Topic: Posted a few auctions...

[CharlesTurner]

http://www.ebay.com/sch/caspian65/m.html?item=291202128301&viewitem=&vxp=mtr&rt=nc&_trksid=p2047675.l2562

[CharlesTurner]

1st round over, next batch listed... 

[ruppstang]

Charles are you going out of business?

[CharlesTurner]

Charles are you going out of business?

Never had a business, lol.  Just selling off stuff I don't need.

[79mustangcobra]

Those fuel sending units are getting rare

[CharlesTurner]

Round 3 listed today...

http://www.ebay.com/sch/caspian65/m.html?item=291202128301&viewitem=&vxp=mtr&rt=nc&_trksid=p2047675.l2562

[67gtasanjose]

I was watching those shock absorbers last week...went higher than I was willing to go. Maybe they are worth more because they were "touched" by famous C.T. 

[CharlesTurner]

Round 4!

http://www.ebay.com/sch/caspian65/m.html?item=291202128301&viewitem=&vxp=mtr&rt=nc&_trksid=p2047675.l2562

[67gtasanjose]

I sure would've liked some NOS 67-8 rocker moldings but not looking like it will happen at this time. Way to ROCK those ROCKER moldings Charles  Looking like it's going good as a seller.

I am trying to remember what I paid in 1979 for the set I wish to replace now. I'm thinking it was below $40 on the pair. My, my, how things can change. Shoulda-woulda-coulda been a millionaire if I knew then what I know now!

[CharlesTurner]

I remember seeing 67-8 rocker panel moldings going for $500-600 in the past, so think they are on-target.  One of those pieces that are superior in every respect to repro.

[drummingrocks]

Charles, I wish you'd had the other side of the '67-68 quarter extension!  I was looking for a driver's side extension a few weeks ago but found one.

[67gta289]

Charles, can you kindly provide the dimensions of the wood steering wheel pieces on eBay?  I have a few sets and they look the same, but dimensions should tell the story. Thanks

[CharlesTurner]

Charles, can you kindly provide the dimensions of the wood steering wheel pieces on eBay?  I have a few sets and they look the same, but dimensions should tell the story. Thanks

I'm confused, what dimensions?  The top plate is the same for all '67 wood grain wheels.  The bottom is thinner for tilt columns.

[67gta289]

sorry about that, I'm looking for the dimension on the bottom piece for a tilt column app.  Need less work and more sleep...

[CharlesTurner]

Really not sure what dimensions you are after.  What makes them different is the height.  This one is a little over 3.5" in diameter and a little over 1/2" from base to top edge.