« previous next »
Pages: [1]   Go Down

Author Topic: 9" Center Section  (Read 1493 times)

Offline orgnl70

  • Jr. Member
  • **
  • Posts: 56
9" Center Section
« on: March 21, 2014, 09:43:57 PM »
For an early 67, Metuchen built car, with a 9" rear. What would be the correct finishes for the pinion snubber bracket or "hood" and the drive shaft yoke?
Thanks in advance
Logged

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9366
Re: 9" Center Section
« Reply #1 on: March 21, 2014, 10:38:50 PM »
Quote from: orgnl70 on March 21, 2014, 09:43:57 PM
For an early 67, Metuchen built car, with a 9" rear. What would be the correct finishes for the pinion snubber bracket or "hood" and the drive shaft yoke?
Thanks in advance
Bare steel on the pinion snubber bracket and bare cast steel on the yoke. The shield that is pressed into the yoke that covers the pinion seal is also bare steel which will have a brighter finish then the yoke.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24630
Re: 9" Center Section
« Reply #2 on: March 21, 2014, 11:10:26 PM »
Quote from: Bob Gaines on March 21, 2014, 10:38:50 PM
Bare steel on the pinion snubber bracket and bare cast steel on the yoke...........

+1 Also consider that though they were both bare steel they would have a very different look since both are formed differently (one cast the other pressed) so consider this when refinishing them ;)
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline orgnl70

  • Jr. Member
  • **
  • Posts: 56
Re: 9" Center Section
« Reply #3 on: March 22, 2014, 01:35:15 AM »
Great. Thanks again
Logged

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7687
Re: 9" Center Section
« Reply #4 on: March 22, 2014, 01:58:40 AM »
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin
Pages: [1]   Go Up
« previous next »