I think I may have a small issue with the smog setup install. All the parts and hoses are original with the exception of one hose. I'm looking at a pic that Tim L sent me of a CJ and I notice that the drivers side tube and check valve is sitting up pretty high over the motor. the best way to describe it is that the top of the canister lines up with the bottom of the check valve if you draw a line across from side to side. My check valve is pretty much in line with the canister or maybe even a touch lower. There is no way to make any adjustments on the tube as the length on the small cylinder head tubes and ferrules is fixed. It was a bear to get the mounting bracket, coil strap, engine tag and the bolt to all come together but I sweat ed it out in the garage with temps over 100 and got it done. This car has no AC and the one in Tim's pic does. Were there two sets of drivers side tubes for AC and without? I'm sure that the canister bracket mounts to the intake manifold radiator neck at the upper LH side bolt so the canister height is fixed. The S hose goes below the heater hose. Everything else seemed to come together OK.