« previous next »
Pages: [1]   Go Down

Author Topic: Valve cover modification  (Read 264 times)

Offline MountainGator

  • Newbie
  • *
  • Posts: 4
Valve cover modification
« on: February 23, 2025, 06:49:31 PM »
When I was cleaning up the valve covers for my 67 GT500, I noticed that part of the fin on the left valve cover had been removed to make a bit more room for the master cylinder. Is this standard, or a custom modification?






« Last Edit: February 23, 2025, 06:51:35 PM by MountainGator »
Logged

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9452
Re: Valve cover modification
« Reply #1 on: February 23, 2025, 09:33:09 PM »
Quote from: MountainGator on February 23, 2025, 06:49:31 PM
When I was cleaning up the valve covers for my 67 GT500, I noticed that part of the fin on the left valve cover had been removed to make a bit more room for the master cylinder. Is this standard, or a custom modification?


It is a standard modification on the 67 GT500 valve cover.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline MountainGator

  • Newbie
  • *
  • Posts: 4
Re: Valve cover modification
« Reply #2 on: February 24, 2025, 12:28:51 PM »
Apparently machining off part of the fin did not give quite enough room - looks like someone took a file to it for a little bit more clearance. Oh well, can't be easily seen.
Logged
Pages: [1]   Go Up
« previous next »