Topic: 1967 Convertible stock ride height

[stevenlake226]

Hello
I am ordering new Eaton springs for my 1967 Base mustang convertible with Power steering as the only option. The car was built in the San Jose factory in 4/67.
I would like to level the car and was wondering if anyone knows the original factory ride height front and rear?

Thanks
Bob

[J_Speegle]

Bob you might want to try the Shop Manual. Not sure if its there but think it is your best shot. If I recall correctly when I researched the subject for other years I came up short in finding the measurements for 67 Mustang. If I recall correctly did find 67 Cougar and those (for the front suspension at least) measured from the upper A arm to the movement stop bumper just above the A arm

[ruppstang]

I think you are correct it is in the chassis assembly manual.

[jwc66k]

I think you are correct it is in the chassis assembly manual.

Page 13, Mustang and Cougar (Ref AM0020). It lists "Standard" and "GT & Imp HDLG Package". The measurements are from the ground to the lower edge of the wheel well with a lot (yes it is TWO words) of "caveats" and instructions (like a full tank of gas).
Jim
And one more time - GET A SET FOR YOUR YEAR CAR. Cougar guys pay attention.

[stevenlake226]

Thanks for all the information

Bob