« previous next »
Pages: [1]   Go Down

Author Topic: 67 Fastback doors  (Read 1042 times)

Offline orgnl70

  • Jr. Member
  • **
  • Posts: 56
67 Fastback doors
« on: May 23, 2024, 10:54:41 AM »
67 Fastback with factory Convenience group. At some point the doors were replaced with non convenience group doors.  No cutout for courtesy light and no pass thru on A pillar for wiring to the door.. The cutout is no problem. What is the location of the pass thru? Was there any shielding or protective cover from the pillar to the door? Any photos would be of great help.
Thanks
Logged

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24628
Re: 67 Fastback doors
« Reply #1 on: May 24, 2024, 05:59:07 PM »
Hope this helps. Happens to be a San Jose built car not sure where your car was built or when. May make a difference

Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline 67gta289

  • Hero Member
  • *****
  • Posts: 3080
Re: 67 Fastback doors
« Reply #2 on: May 24, 2024, 08:18:43 PM »
If my memory is correct there are locating dimples in the sheet metal that you can use for reference
Logged
John
67 289 GTA Dec 20 1966 San Jose
7R02C156xxx
MCA 74660

Offline gtamustang

  • CPM
  • Global Moderator
  • Sr. Member
  • ****
  • Posts: 297
Re: 67 Fastback doors
« Reply #3 on: May 25, 2024, 06:48:53 PM »
Quote from: 67gta289 on May 24, 2024, 08:18:43 PM
If my memory is correct there are locating dimples in the sheet metal that you can use for reference

Your memory is still going strong; There are locating dimples on the door and on the door pillar.

Regards,
gtamustang
Logged
Pages: [1]   Go Up
« previous next »