Author Topic: Vinyl dipped clip  (Read 777 times)

Offline V8_bloke_28

  • Full Member
  • ***
  • Posts: 122
Vinyl dipped clip
« on: June 21, 2021, 06:00:22 AM »
Hi
Im after this clip/clamp that holds the little vacuum hoses on the firewall.
Car is 67 fack 390gt auto. San Jose.
It has factory ac.
Can someone tell me what it?s actually called and where I can get one from?
Cheers

Offline ruppstang

  • Hero Member
  • *****
  • Posts: 3936
Re: Vinyl dipped clip
« Reply #1 on: June 21, 2021, 08:37:55 AM »
IMHO they are not reproduced. You will have to find a original or make one. They are not that hard to make.

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9360
Re: Vinyl dipped clip
« Reply #2 on: June 21, 2021, 10:27:03 AM »
IMHO they are not reproduced. You will have to find a original or make one. They are not that hard to make.
+1. I have had to do both on more then one occasion over the years.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline preaction

  • Hero Member
  • *****
  • Posts: 1330
Re: Vinyl dipped clip
« Reply #3 on: June 21, 2021, 11:53:35 AM »
You could try WCCC.
8F02R218047-  July 18 1968   Dearborn

Offline 1967FEGT

  • Jr. Member
  • **
  • Posts: 96
Re: Vinyl dipped clip
« Reply #4 on: June 21, 2021, 03:07:16 PM »
I have one in about NOS condition if you're in need.

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24623
Re: Vinyl dipped clip
« Reply #5 on: June 21, 2021, 05:46:43 PM »
IMHO they are not reproduced. You will have to find a original or make one. They are not that hard to make.

+2 Were used on other Ford and Mercury products but you'll need to double check if they are the same size. We did get into a short discussion about a possible difference  but we didn't go down that rabbit hole so the question went unsolved at that point in the conversation
Jeff Speegle

Anything worth doing is worth doing concours ;)