Author Topic: Electrical Wire Loom Clip - Dash Left Side  (Read 907 times)

Offline must69

  • Full Member
  • ***
  • Posts: 198
Electrical Wire Loom Clip - Dash Left Side
« on: March 26, 2021, 02:05:02 PM »
Trying to find where this clip goes. Assy manual indicates there is a bendable clip attached to the underside of the cowl at the FA vent but this has a nut and bolt attached to it that came off that way so unsure that is where it goes.  Any ideas?  July 13, 1964 Dearborn production Coupe.
Thanks.
Phil

Online jwc66k

  • Hero Member
  • *****
  • Posts: 7347
Re: Electrical Wire Loom Clip - Dash Left Side
« Reply #1 on: March 26, 2021, 04:37:21 PM »
The 64 Electrical Assembly Manual shows the clip with part number 370805-S100 (it's a lot easier if you list the part number of the item that you find in the assembly manuals) as being attached with a screw, 42127-S8, to a metal body piece tucked in the upper left corner. Your nut and screw/bolt in the picture may be misleading. There is another clip shown (different part number, 377904-S) attached with a nut (34655-S7) to a stud to the right of the vent.
Note: Screw 42127-S8, is shown with a quantity of 2, but only one appears on the drawing.
Jim
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline must69

  • Full Member
  • ***
  • Posts: 198
Re: Electrical Wire Loom Clip - Dash Left Side
« Reply #2 on: March 26, 2021, 07:20:31 PM »
Jim, that is the clip. There was reference to at least two clips so I was not sure which one it was and that is why I reached out for help and the fastener did not make sense either. Just looked under there and that is also the screw mounting location for the cardboard wiper transmission cover so it is a dual purpose hex screw. Thanks for your help. Sometimes the simplest things cause problems.
Phil

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7687
Re: Electrical Wire Loom Clip - Dash Left Side
« Reply #3 on: March 26, 2021, 08:51:35 PM »
There is one like this attached to the bottom edge of the dash on the left side.  The fasteners look correct for that one.  We have discussed before here, but I couldn't find the topic.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline must69

  • Full Member
  • ***
  • Posts: 198
Re: Electrical Wire Loom Clip - Dash Left Side
« Reply #4 on: March 26, 2021, 09:11:30 PM »
Charles, well I was fairly confident about that nut and bolt fastener, but for now I?ll leave it up top until some other evidence pops up.  Thanks!
Phil

Offline ChrisV289

  • Hero Member
  • *****
  • Posts: 1965
Re: Electrical Wire Loom Clip - Dash Left Side
« Reply #5 on: March 27, 2021, 12:09:13 PM »
There is one like this attached to the bottom edge of the dash on the left side.  The fasteners look correct for that one.  We have discussed before here, but I couldn't find the topic.

Found it:

http://www.concoursmustang.com/forum/index.php?topic=21508.msg135069#msg135069
Chris
1965 Honey Gold Fastback (SJ 10/29/64)
1965 Caspian Blue Fastback (SJ 06/03/65)
2009 V6 Mustang Coupe

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24628
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline must69

  • Full Member
  • ***
  • Posts: 198
Re: Electrical Wire Loom Clip - Dash Left Side
« Reply #7 on: March 27, 2021, 07:51:42 PM »
Found it:

http://www.concoursmustang.com/forum/index.php?topic=21508.msg135069#msg135069
Thank you!  That is it.  As you can see by my original pic it is a hex bolt with a nut, like a tail light nut.  My dash has been painted so there has been no trace markings.  Thanks Chris, Charles & Jeff for the diligence! One more detail checked off.
Phil