Author Topic: Axle vent (Read 784 times)

rocnhrse · « **on:** February 11, 2021, 10:20:56 AM »

67 mustang, 9 in rear end,3.00 gear,the vent has a what appears to be a rubber hose extension, with a clamp,how long would that hose typically be

Bob Gaines · « **Reply #1 on:** February 11, 2021, 01:54:44 PM »

67 mustang, 9 in rear end,3.00 gear,the vent has a what appears to be a rubber hose extension, with a clamp,how long would that hose typically be

19 1/2 is what one measured out of the NOS service kit.

rocnhrse · « **Reply #2 on:** February 11, 2021, 02:07:53 PM »

Thanks Bob, I am going to need a schematic, because at that length its going to fastened to something, maybe some one has a picture of this area

67gta289 · « **Reply #3 on:** February 11, 2021, 02:27:35 PM »

you don't have the chassis assembly manual? Did you look at the unrestored picture area?

67gta289 · « **Reply #4 on:** February 11, 2021, 02:59:37 PM »

rocnhrse · « **Reply #5 on:** February 11, 2021, 03:13:51 PM »

Thanks Richard, I found it in the chassis manual, went through it twice finally saw it in s corner, need new bifocals, thanks

67gtasanjose · « **Reply #6 on:** February 11, 2021, 05:14:11 PM »

Thanks Richard, I found it in the chassis manual, went through it twice finally saw it in s corner, need new bifocals, thanks

That was not RICHARD

rocnhrse · « **Reply #7 on:** February 11, 2021, 08:50:08 PM »

I stand corrected,have a appointment with optometrist

News: