Topic: 68 Mustang Seat Rail

[Corey Bowcutt]

One of the threaded studs that mount my driver's seat to the floor has damaged threads.  I am not sure if these threaded studs can be pressed out and replaced of not?  Does anyone out there have a spare seat rail with good studs or if the studs can be removed does anyone have any replacement studs?
Thank you,
Corey

[carlite65]

can you run a thread die over them & clean it up??

[RoyceP]

Run a 5/16' - 18 NC die over it. If that doesn't work you can buy one side or a whole assembly from WCCC:
https://secure.cougarpartscatalog.com/67tracksetbench.html?sessionthemeid=26

One of the threaded studs that mount my driver's seat to the floor has damaged threads.  I am not sure if these threaded studs can be pressed out and replaced of not?  Does anyone out there have a spare seat rail with good studs or if the studs can be removed does anyone have any replacement studs?
Thank you,
Corey

[Bossbill]

I think a good quality tap and die set is the most underrated item in the tool box.

[midlife]

I think a good quality tap and die set is the most underrated item in the tool box.

That and a credit card.

[jwc66k]

There is one listed by AMK ( www.amkproducts.com ), B-11662. It is 1 7/16 inch long, I assume the measurement is made from under the head to the end of the lead point tip. I don't know if that is the same length used on your seat track, but is may be a viable option.
Jim

[Corey Bowcutt]

A lot of great help here.  Thank you guys.

Corey