Topic: 65 and 66 Fastback Fold Down Latch Cover Screws?

[J_Speegle]

Looking for input on what owners of unrestored 65 & 66 fastbacks have found as the original hardware (screws) used to retain the thin sheet metal covers over the fold down latches.

Not an easy place to take pictures of and so many cars are shown with the seat in the upright setting making it even more difficult to see and get a good angle of

Thanks for looking and helping out. Please include when and where your example was built

[jwc66k]

Having both a 65 and 66 Fastback (both San Jose, 5-11-65 and 10-18-65 builds), the screws are as indicated in the spreadsheet for 64-66 Mustangs in the Forum's library, 4 each required, 53016-S13 8-15X1/2 Oval Head 17/64, Phillips for 65 and 53008-S13 8-18X1/2 Oval Head 17/64, Phillips for the 66. Both types of screw are chrome plated and use a finishing washer 34968-S No 6, stainless (it's a tight fit).
Jim

[sgl66]

Having both a 65 and 66 Fastback (both San Jose, 5-11-65 and 10-18-65 builds), the screws are as indicated in the spreadsheet for 64-66 Mustangs in the Forum's library, 4 each required, 53016-S13 8-15X1/2 Oval Head 17/64, Phillips for 65 and 53008-S13 8-18X1/2 Oval Head 17/64, Phillips for the 66. Both types of screw are chrome plated and use a finishing washer 34968-S No 6, stainless (it's a tight fit).
Jim

Picture = 1,000 words comes to mind right about now

[jwc66k]

Picture = 1,000 words comes to mind right about now

You get "500". The garage is crowded.
Jim

[sgl66]

Thanks Jim

The screws look like what I have minus the washers which very likely could have been lost at some point.

I picked up these replacements I think from VA Mustang but never got around to putting them on

[ChrisV289]

So here is mine. Oct of 64. Mine has the “washer” molded into the latch piece. Is this an early feature?

[jwc66k]

So here is mine. Oct of 64. Mine has the “washer” molded into the latch piece. Is this an early feature?

They are painted over.
Jim

[ChrisV289]

They are painted over.
Jim

Jim, I'll take a screw out later to confirm but pretty sure the washer isn't separate.  Also if you look the piece does not have the grain, it is smooth....

[jwc66k]

Take out all four screws, turn the cover over and see if there is a "formed" base for the screw. Then use a screwdriver to knock off the washer (AMK 2014 pg 185, B-10375).
Jim

[ChrisV289]

Stand corrected. Very tiny screw