« previous next »
Pages: [1]   Go Down

Author Topic: Is this the correct throw out bearing fork?  (Read 645 times)

Offline jtrue

  • Newbie
  • *
  • Posts: 16
Is this the correct throw out bearing fork?
« on: June 06, 2017, 07:01:11 PM »
Hi, when I bought my 66 Mustang 4 speed, it had an incorrect bellhousing installed. I found the correct C5DA-6394-A and it came with a separate fork. Is this the correct one? It's about 12-1/8" long. Can anyone tell by this photo? I probably should have asked before I went to the trouble of sandblasting it. Also, is the little anti-Rattle spring the only thing I need to install it? Thanks for any help.

Mark
Logged

Offline Texas Swede

  • Full Member
  • ***
  • Posts: 239
Re: Is this the correct throw out bearing fork?
« Reply #1 on: June 06, 2017, 07:23:28 PM »
It looks correct to me and yes, the rattle spring is the only thing holding it.
Texas Swede
Logged

Offline jtrue

  • Newbie
  • *
  • Posts: 16
Re: Is this the correct throw out bearing fork?
« Reply #2 on: June 06, 2017, 07:27:05 PM »
Quote from: Texas Swede on June 06, 2017, 07:23:28 PM
It looks correct to me and yes, the rattle spring is the only thing holding it.
Texas Swede

Thank you!
Logged
Pages: [1]   Go Up
« previous next »