« previous next »
Pages: [1]   Go Down

Author Topic: Parts Id please  (Read 1059 times)

Offline Drive Fast

  • Newbie
  • *
  • Posts: 12
Parts Id please
« on: October 04, 2016, 03:25:01 AM »
Can anyone tell me where these parts go?

I'm building a 69 R code Mach 1 that was disassembled, in boxes, when I bought it. I have no clue where everything goes. I keep reading and looking, but no luck so far.

Thank you
Logged

Offline Vcode

  • Full Member
  • ***
  • Posts: 134
Re: Parts Id please
« Reply #1 on: October 04, 2016, 07:14:19 AM »
The three black brackets look like lower radiator mounting brackets.
You only need two - there is a left & right side.
Logged

Offline Brian Conway

  • Hero Member
  • *****
  • Posts: 1623
Re: Parts Id please
« Reply #2 on: October 04, 2016, 09:30:28 AM »
Ditto on the lower radiator supports brackets.  You will need the rubber pads.  Don't recognise the part on the left.  I don't have AC, PS or any other extras.  Maybe that's why ?  Brian
Logged
5RO9A GT  4 Spd Built 5/29/65
9TO2R SCJ 4 Spd Built 9/19/68
Owner Driver Mechanic
San Diego, Ca.

Offline VikingNJ

  • Jr. Member
  • **
  • Posts: 81
Re: Parts Id please
« Reply #3 on: October 04, 2016, 10:26:16 AM »
Way back a few years, someone on this site I recall or it could have been ebay, was discussing about the first bracket and mentioned it was a choke check bracket for a 4V 351W. Just a thought.
Logged

Offline VikingNJ

  • Jr. Member
  • **
  • Posts: 81
Re: Parts Id please
« Reply #4 on: October 04, 2016, 12:57:23 PM »
Sorry, the bracket is a choke shield bracket  for 4V carburetor.
« Last Edit: October 04, 2016, 05:25:01 PM by VikingNJ »
Logged
Pages: [1]   Go Up
« previous next »