Author Topic: Quarter panel end cap  (Read 957 times)

Offline 13Outlaw

  • Full Member
  • ***
  • Posts: 123
Quarter panel end cap
« on: March 13, 2016, 08:08:08 PM »
Ok not sure if that's the correct name for it or not; however, would someone verify for me that there is a gap between the end cap and the inside corner of the taillight panel? It's been awhile since I've seen mine in one piece and pictures are hard to tell. Appears to be about a finger tip width gap?
1969 Mach 1 R-Code 4-Speed (Dearborn built Jan 69)
1992 GT 5.0 5-Speed
2003 Cobra
2013 Shelby GT500

Offline Brian Conway

  • Hero Member
  • *****
  • Posts: 1623
Re: Quarter panel end cap
« Reply #1 on: March 13, 2016, 10:40:24 PM »
  Picture, my car, is of the areas I think your are describing.  On the Left the gap is about 1/4" and on the right closer to 1/8".  Brian
5RO9A GT  4 Spd Built 5/29/65
9TO2R SCJ 4 Spd Built 9/19/68
Owner Driver Mechanic
San Diego, Ca.

Offline 13Outlaw

  • Full Member
  • ***
  • Posts: 123
Re: Quarter panel end cap
« Reply #2 on: March 13, 2016, 10:59:17 PM »
Brian, your car looks amazing! Same color as mine, well as mine will be again anyway. Yes that's the area I'm talking about. Mine looks a little bigger I think, I did the best I could to get the panel pulled back as far as possible against the quarter extension piece, but I think some times that's the raw deal with after market parts even when u buy the best sold..
1969 Mach 1 R-Code 4-Speed (Dearborn built Jan 69)
1992 GT 5.0 5-Speed
2003 Cobra
2013 Shelby GT500