« previous next »
Pages: [1]   Go Down

Author Topic: 1967 Mustang 390 steering column shaft finish.  (Read 979 times)

1967 eight barrel

  • Guest
1967 Mustang 390 steering column shaft finish.
« on: February 24, 2016, 12:55:11 AM »
What would be the original finish on a the steering column shaft? Look to have been P&O.


                                                                                            -Keith
« Last Edit: February 24, 2016, 04:35:47 PM by 1967 eight barrel »
Logged

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7346
Re: 1967 Mustang 390 steering column shaft fisnish.
« Reply #1 on: February 24, 2016, 12:03:40 PM »
I think it's forged steel so it would be a dark natural finish. To clean it up, a dark phosphate finish would be my choice.
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9360
Re: 1967 Mustang 390 steering column shaft fisnish.
« Reply #2 on: February 24, 2016, 03:12:10 PM »
Quote from: jwc66k on February 24, 2016, 12:03:40 PM
I think it's forged steel so it would be a dark natural finish. To clean it up, a dark phosphate finish would be my choice.
Jim
+1
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

1967 eight barrel

  • Guest
Re: 1967 Mustang 390 steering column shaft finish.
« Reply #3 on: February 24, 2016, 04:39:21 PM »
Thanks, gentlemen. I used the 390 reference so others would know it was a two piece '67 column. It had been spray painted initially.           
Logged
Pages: [1]   Go Up
« previous next »