Author Topic: Early San Jose C code Correct ignition coil location?  (Read 5562 times)

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9358
Re: Mustang 67 Position + colour of Ignition Coil
« Reply #15 on: October 30, 2017, 11:54:57 AM »
Coming back to this one.

What is the original colour (+ eng/part. number) of the early 67 ignition coil (in german Zündspule)?  Yellow cap, black body?


Thx
Ralf
Semi gloss black body and Mustard Yellow top as has been mentioned . The trademark/date stamp had little variation for 67 production and would typically have the Autolite trademark and relevant date stamp  . Given the location of where it is stamped , the orientation of where it is place on the coil , where the coil is placed in the coil bracket and engine identification sticker placed on the coil  , it is hard if not impossible to see the stamp once installed. Maybe only a edge of the stamp is visible and maybe not. The coil body many times came with small dings and dents before being placed in the bracket so don't be much concerned about that. The most important thing IMO is the condition and appearance of the top of the coil and the coil bracket details.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24620
Re: Mustang 67 Position + colour of Ignition Coil
« Reply #16 on: October 30, 2017, 05:37:57 PM »
Semi gloss black body and Mustard Yellow top as has been mentioned ........... where the coil is placed in the coil bracket and engine identification sticker placed on the coil  ,.........................

Ralf

Since your car is a San Jose built car the engine ID sticker would not have been placed on the coil like it was at the other two plants. The Engine ID sticker would have been attached to the stock drivers side valve cover front face.  Think Bob's mind is on San Jose 67 Shelby's at the moment 

Just one detail in a bunch of good info provided to you
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9358
Re: Mustang 67 Position + colour of Ignition Coil
« Reply #17 on: October 30, 2017, 08:32:55 PM »
Ralf

Since your car is a San Jose built car the engine ID sticker would not have been placed on the coil like it was at the other two plants. The Engine ID sticker would have been attached to the stock drivers side valve cover front face.  Think Bob's mind is on San Jose 67 Shelby's at the moment 

Just one detail in a bunch of good info provided to you
Yes I have somewhat tunnel vision in that regard. With or without the paper sticker the viewing of the coil stamp is basically the same.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby