« previous next »
Pages: [1]   Go Down

Author Topic: 69 351 windsor starter  (Read 1220 times)

Offline 1969 Cale II

  • Full Member
  • ***
  • Posts: 241
69 351 windsor starter
« on: February 27, 2015, 10:46:42 AM »
How should a starter be finished for a 69 351 w auto? Is there any part numbers on them ? Any photos of finished or clean originals?
Logged

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9366
Re: 69 351 windsor starter
« Reply #1 on: February 27, 2015, 12:09:21 PM »
Quote from: 1969 Cale II on February 27, 2015, 10:46:42 AM
How should a starter be finished for a 69 351 w auto? Is there any part numbers on them ? Any photos of finished or clean originals?
The entire starter will be painted up to almost the block end .There is no tape line because a mask was used . A soft edge (foggy line).  The end wasn't completely painted so the starter could achieve a good ground. The engineering number was metal stamped into the case.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24630
Re: 69 351 windsor starter
« Reply #2 on: February 27, 2015, 05:36:48 PM »
Quote from: 1969 Cale II on February 27, 2015, 10:46:42 AM
....... Any photos of finished or clean originals?

Did you try a search? - believe pictures have been posted in at least a couple of threads 
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)
Pages: [1]   Go Up
« previous next »