Topic: Rubber Shield Fasteners

[imnutz66]

Can someone tell me what fastener was used to install the rubber flap above the rear license plate on 70's? I have the holes there, but the flap was removed by PO along with the fasteners

Thanks, Joe

[Bill73Ragtop]

My 69 vert had philips head screws.  It was original as far as I could tell.  I replaced them with stainless screws when re-assembling.

[cobrajetchris]

The ones I have seen are all round head Phillips screws that are very short and have a black phosphate type coating, I am sure AMK fasteners would have them.

[imnutz66]

Thanks for the info, were they round head for sure and not pan head?

[J_Speegle]

Only seen round head phillips used

[rockhouse66]

This is from a 1969 Dearborn car.  I am sure the original finish was P&O.

[imnutz66]

That picture is great, I actually have a handful of screws identical to that - if I can just remember exactly where they are!

[Bob Gaines]

Those screws look like the screws  at the bottom that hold the interior dash trim pieces of the two in the center (ether side of radio)and two outer trim panels on a 69. AMK sells them. Bob