Topic: Pulley ID - FoMoCo "P"

[Oz390]

Have a 4 bolt pulley, aligns to a water pump pattern, single sheave, ~5 7/8" OD. 

Only markings are FoMoCo stamp and a "P",  can find no reference to identify its original use... anyone know?

[krelboyne]

I believe that "P" is a manufacturers mark. Some pulleys were ink stamped.

[67gtasanjose]

Would need a measurement of offset too to have a chance at getting an I.D. of this pulley. Lay it face down and measure to top edge of pulley and maybe shoot us an image.

Richard

[Oz390]

Front face is flat, center hub even with edge of sheave.

Cleaned it up a bit more and found a faint C6AE-9B447-E  (I think),  that is a smog pump pulley....?  67 S code smog is one reference I found...