« previous next »
Pages: [1]   Go Down

Author Topic: steering column spacers  (Read 816 times)

Offline redmach69

  • Newbie
  • *
  • Posts: 19
steering column spacers
« on: October 10, 2013, 06:08:49 PM »
Hey guys, I was wondering on my Mach 1 could I remove the 1 set of additional spacers between the steering column and the dash? If I did so, it sure would be easier to get in and out (not as thin as I used to be) but would it mean the instrument cluster, or the lower dash cover, or the rubber trim piece would then not fit?
Thanks.
Logged

Offline specialed

  • Hero Member
  • *****
  • Posts: 1095
Re: steering column spacers
« Reply #1 on: October 10, 2013, 06:54:29 PM »
the rubber donut column seal is different between fastback & coupe &vert & 2 alum spacers verses 1.
Logged

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24623
Re: steering column spacers
« Reply #2 on: October 10, 2013, 08:35:34 PM »
Yes you can remove one of the two (each side) spacers but as Ed mentioned you'll need to get a new donut to better cover the gap created. This will tilt the steering wheel more skyward and change the angle of the wheel to driver.
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)
Pages: [1]   Go Up
« previous next »