« previous next »
Pages: [1]   Go Down

Author Topic: 70 engine feed harnass  (Read 1255 times)

Offline joe747

  • Full Member
  • ***
  • Posts: 172
70 engine feed harnass
« on: January 15, 2012, 05:18:44 PM »
want to install the engine feed harnass (one that comes from the coil .were there some kind of clips that it attaches to
Logged

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7310
Re: engine feed harnass
« Reply #1 on: January 15, 2012, 05:40:33 PM »
What year, what engine?
Jim
And get a set of Mustang Assembly Manuals for your car's years.
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline joe747

  • Full Member
  • ***
  • Posts: 172
Re: engine feed harnass
« Reply #2 on: January 15, 2012, 05:46:37 PM »
1970 mustang 351 cleveland engine
Logged

Offline Carl

  • Jr. Member
  • **
  • Posts: 53
Re: 70 engine feed harnass
« Reply #3 on: January 15, 2012, 09:40:44 PM »
Unfortunately, there's no engine assembly manual for '70s, but good news, the clips are shown in the electrical assemmbly manual.  As books go, its probably the most worthwhile piece for restoring a '70.
There's 2 J clips that hold the wiring in place, the first on the farthest back and highest valve cover bolt driver's side valve cover, the second being on the second in from the back valve cover bolt (top row) on the passenger side valve cover.  Clips are Ford Number 356640-S100, AMK had a VERY close substitute, that just needed a bit of bending to work.  Two more of the same clips are used for the solenoid wire if you have AC, they go on the second and third in from the back valve cover bolts on the drivers side valve cover.

  Carl
Logged
Pages: [1]   Go Up
« previous next »