Topic: 7AB power steering pulley

[MAdams08]

Anyone have a 7AB power steering pulley that would be willing to sell?

[J_Speegle]

Welcome to the site

Guess your already aware that these are reproduced.

https://www.deadnutson.com/1967-shelby-gt500-power-steering-pulley-7ab/



But of course you might be looking for an original or one, possibly, at a lower price. Good luck with your search 

[Bob Gaines]

Welcome to the site

Guess your already aware that these are reproduced.

https://www.deadnutson.com/1967-shelby-gt500-power-steering-pulley-7ab/



But of course you might be looking for an original or one, possibly, at a lower price. Good luck with your search 

The repros are heavier because they are made out of billet steel unlike original  which is not . Other then that they are identical. Of course you can not tell once installed .

[J_Speegle]

The repros are heavier because they are made out of billet steel unlike original  which is not . Other then that they are identical. Of course you can not tell once installed .

Isn't there also the lack of the seam where on the two piece original section joined. On the repo - at least on the others made out of one piece billet there is just a machine edge rather than steel over steel. Small detail but still a difference if made by the same guy/company for their reproductions

[MAdams08]

I have been lookin at dead nuts on but they have been unavailable for a while now. Created ad to see if anyone on the site may know of one for sale or have one in their personal inventory looking to sale.

[carlite65]

do a search here for 'chokostang'. he rebuilds p.s. units.

[Bob Gaines]

I have been lookin at dead nuts on but they have been unavailable for a while now. Created ad to see if anyone on the site may know of one for sale or have one in their personal inventory looking to sale.

Hank Huisman is the one making them. Paradise Automotive (813) 920-7544 . Fax (813) 926-9662 . 1022 Gunn Hwy. Odessa, Fl 33556 info@ascmclaren.com . Tell him I said hey.

[Bob Gaines]

Isn't there also the lack of the seam where on the two piece original section joined. On the repo - at least on the others made out of one piece billet there is just a machine edge rather than steel over steel. Small detail but still a difference if made by the same guy/company for their reproductions

That seam detail on originals can only be seen from the back side of the pulley which of course is impossible to be seen once installed. The thin front side seam is filled in with paint and can't be seen. 

[S412gofast]

For reference here is a pic of an original one that I sold