Topic: Correct Assembly Line nuts for exhaust manifolds to H pipe?

[Kyle Zammit]

Hi all,

I am looking for unrestored 67 390GT or 67 Shelby GT500 pictures shows the exhaust manifolds nuts for the exhaust H pipe.

I need to know how is the shape of the nut.

Thanks Kyle.

[jwc66k]

Did you look in this forum's library under topic "Mustang Hardware Spreadsheet 67-68", file MHW67-68AP06.xlsx?
Jim

[Kyle Zammit]

Hi, thanks.

But I didn't find a picture.

[J_Speegle]

Hi, thanks.

But I didn't find a picture.

Must have overlooked or missed the picture in the Unrestored Picture Section

Try picture EC-19 under the thread - 67 San Jose 390 GTA Fastback - Unrestored Picture Thread

Originals with some surface rust only. Typical shouldered nut used for this purpose for cars from the mid 60's

Likely have more examples but believe that one should give you what your looking for

[196667Bob]

Kyle : Maybe the attached will help.

Bob

[J_Speegle]

Kyle : Maybe the attached will help.

Bob

Kyle - Just to make certain you don't get confused there are two pictures in Reply #4 the one on the left matches the picture of the originals in the thread I mentioned.

And for part number, since there are two highlighted the lower one (375918-S) is the one listed in the MPC as a replacement and or original as shown below. Happens to be an illustration taken from a 72 version of the MPC. Don't have the illustrated section for my 67 MPC    Sure the correct part number is right there in Jim's list

[Kyle Zammit]

Ok thanks to all.

I found the picture on the unrestored section EC-19 Thanks a lot Jeff.

[196667Bob]

The two Part Numbers thast I noted are both shown in Jim's List, as well as in the 1967 Chassis Assembly Manual, wherethey are listed as "Alt".

Bob