« previous next »
Pages: 1 [2]   Go Down

Author Topic: 1970 Mach1 Trunk Pinch Weld Cover  (Read 1330 times)

Offline 67gta289

  • Hero Member
  • *****
  • Posts: 3080
Re: 1970 Mach1 Trunk Pinch Weld Cover
« Reply #15 on: February 08, 2021, 11:40:00 AM »
Interesting.  I recently grabbed this out of a 69 Mach 1 dual exhaust car near me in a junkyard.  No VIN. 
Logged
John
67 289 GTA Dec 20 1966 San Jose
7R02C156xxx
MCA 74660

Offline alanmac

  • Full Member
  • ***
  • Posts: 177
Re: 1970 Mach1 Trunk Pinch Weld Cover
« Reply #16 on: February 08, 2021, 03:43:39 PM »
I measured the pinch weld flange, a 10" protector will not fit.  Looks like ~ 8.5" doesn't cover the tie wrap hole and seems correct. 
Logged
1970 Mustang Mach 1
351W Shaker Hood
Built at Metuchen
1 of 186 with these paint/trim codes
Build Date: October 7, 1969
0T1190xx
Dealer: Maguires Garage Inc. Duncannon PA
Pages: 1 [2]   Go Up
« previous next »