Author Topic: Sequential Lamp Module Mounting Hook  (Read 861 times)

Offline ninedrvr

  • Full Member
  • ***
  • Posts: 205
Sequential Lamp Module Mounting Hook
« on: March 01, 2021, 09:34:27 PM »
Anyone have a picture of the hook/bracket the sequential module hangs from in the left trunk drop off area? I have one coming from a 69 Cougar but I need to figure out where to weld it on.

1969 GT500 Convertible Recreation

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24605
Re: Sequential Lamp Module Mounting Hook
« Reply #1 on: March 02, 2021, 12:32:43 AM »


Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline ninedrvr

  • Full Member
  • ***
  • Posts: 205
Re: Sequential Lamp Module Mounting Hook
« Reply #2 on: March 02, 2021, 06:38:03 AM »
Thanks Jeff
1969 GT500 Convertible Recreation

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9333
Re: Sequential Lamp Module Mounting Hook
« Reply #3 on: March 02, 2021, 12:22:10 PM »
If you want it to look original don't try and reinvent the wheel and do it better. The welding workmanship was adequate at Best. That is unless you don't care about originality and want to weld it better. I am a admitted terrible welder and can do better then what was typically done on installing that bracket. If it looks too good it is a tip off that it has been replaced for some reason.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline ninedrvr

  • Full Member
  • ***
  • Posts: 205
Re: Sequential Lamp Module Mounting Hook
« Reply #4 on: March 07, 2021, 03:15:40 PM »
I got the hook and I'm ready to weld it on. I just have one concern regarding the placement. What stops this thing from banging around back there? The hook position I am seeing would put the module about 1/2 inch away from the trunk drop off. Is there anything that stops the module from swaying on the hook?
1969 GT500 Convertible Recreation

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24605
Re: Sequential Lamp Module Mounting Hook
« Reply #5 on: March 07, 2021, 05:09:22 PM »
I got the hook and I'm ready to weld it on. I just have one concern regarding the placement. What stops this thing from banging around back there? The hook position I am seeing would put the module about 1/2 inch away from the trunk drop off. Is there anything that stops the module from swaying on the hook?

A section of dense closed cell foam applied to the back (towards the trunk drop panel) of the box

Jeff Speegle

Anything worth doing is worth doing concours ;)