« previous next »
Pages: [1]   Go Down

Author Topic: Shock Tower Hole Question - 66 SJ  (Read 386 times)

Offline KenFirch

  • Newbie
  • *
  • Posts: 24
Shock Tower Hole Question - 66 SJ
« on: July 29, 2019, 03:40:05 PM »
I'm filling up a few holes before painting the engine bay, from alarms, etc.  On the drivers side shock tower there's a hole that I'm not sure of.   Is it a factory hole?

On a 66 SJ Convert.
 
Thanks!
« Last Edit: July 29, 2019, 06:53:32 PM by J_Speegle »
Logged
Current Project: 66 Mustang Convert (6R08A140031 - 12/6/65 Date)
Past: Owner of SFM6S524 1980-2015.

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7306
Re: Shock Tower Hole
« Reply #1 on: July 29, 2019, 04:50:13 PM »
It's not factory. Weld it over. It's looks to be in an odd place to grease the upper "A" arm shaft, which was semi-common.
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline KenFirch

  • Newbie
  • *
  • Posts: 24
Re: Shock Tower Hole
« Reply #2 on: July 29, 2019, 05:43:48 PM »
Done!  I vaguely remember one of those old horns for the alarm being there years ago, but wasn't sure.

Thanks
Logged
Current Project: 66 Mustang Convert (6R08A140031 - 12/6/65 Date)
Past: Owner of SFM6S524 1980-2015.

Offline ChrisV289

  • Hero Member
  • *****
  • Posts: 1965
Re: Shock Tower Hole
« Reply #3 on: July 29, 2019, 05:54:16 PM »
Did the car have AC? Would be where the bracket goes to secure one of the lines
Logged
Chris
1965 Honey Gold Fastback (SJ 10/29/64)
1965 Caspian Blue Fastback (SJ 06/03/65)
2009 V6 Mustang Coupe

Offline KenFirch

  • Newbie
  • *
  • Posts: 24
Re: Shock Tower Hole Question - 66 SJ
« Reply #4 on: July 29, 2019, 08:00:57 PM »
Arghh!  Yes, it is an AC car.  Getting my drill.  LOL.
Logged
Current Project: 66 Mustang Convert (6R08A140031 - 12/6/65 Date)
Past: Owner of SFM6S524 1980-2015.
Pages: [1]   Go Up
« previous next »