« previous next »
Pages: [1]   Go Down

Author Topic: Fitting new cowl  (Read 1309 times)

Offline scottwo

  • Newbie
  • *
  • Posts: 12
Fitting new cowl
« on: July 22, 2018, 07:36:09 PM »
The new cowl has about .300 overhang on the drivers side and .125 on the passengers side where it meets the A pillar.
Anyone else run into this?
It's not clamped down in the pictures and I have a temp. windshield in place. Cowl was purchased at CJ Pony.
It has a nice with the firewall and side cowl panels.

Thanks
Scott
« Last Edit: July 22, 2018, 08:03:24 PM by carlite65 »
Logged

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24623
Re: Fitting new cowel
« Reply #1 on: July 23, 2018, 12:10:10 AM »
Guessing this is for either a 69 or a 70.  Reproduction parts being a bit larger, smaller or shaped differently would likely not surprise many here.  Can't speak directly to your challenge but would expect to have to make things  fit or at least be prepared  when using these parts in a repair
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)
Pages: [1]   Go Up
« previous next »