« previous next »
Pages: [1]   Go Down

Author Topic: 1970 Mustang 428 CJ carburetor spacer and gasket  (Read 1045 times)

Offline Myfo28

  • Newbie
  • *
  • Posts: 17
1970 Mustang 428 CJ carburetor spacer and gasket
« on: September 16, 2017, 01:12:07 PM »
About to install rebuilt D0ZF-AB carburetor on my 1970 Mustang 428 CJ with reproduction spacer and gasket.  Should the gasket be installed as shown or should it be trimmed to match the spacer?  Thanks
Logged
1970 Mustang 428 CJ Convertible
Ravens Black
R Code

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24630
Re: 1970 Mustang 428 CJ carburetor spacer and gasket
« Reply #1 on: September 16, 2017, 03:48:23 PM »
Would install as shown without trimming the tabs for your year and application
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline 7Lscjracer

  • Hero Member
  • *****
  • Posts: 521
Re: 1970 Mustang 428 CJ carburetor spacer and gasket
« Reply #2 on: September 16, 2017, 05:55:57 PM »
+1

All the carb to spacer gaskets I've seen are 4 hole, but spacer to aluminum intake is open plenum while spacer to cast iron intake is again 4 hole.
Logged
69 Mach 1 San Jose Nov. 68 build
Bought May '81, sold Sept '20

Offline Myfo28

  • Newbie
  • *
  • Posts: 17
Re: 1970 Mustang 428 CJ carburetor spacer and gasket
« Reply #3 on: September 16, 2017, 06:48:29 PM »
Thank you both!
Logged
1970 Mustang 428 CJ Convertible
Ravens Black
R Code

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24630
Re: 1970 Mustang 428 CJ carburetor spacer and gasket
« Reply #4 on: September 16, 2017, 07:44:49 PM »
Just make sure the the diameter of the holes in the carb base plate, intake and spacer (well when they have 4  holes) all have the same diameter.

There are gaskets with all kinds of configurations but not normally factory ones ;)
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)
Pages: [1]   Go Up
« previous next »