« previous next »
Pages: [1]   Go Down

Author Topic: 67 GT500 Oil Sender wire hook up  (Read 1281 times)

Offline supersnake

  • Newbie
  • *
  • Posts: 26
67 GT500 Oil Sender wire hook up
« on: September 02, 2015, 01:30:15 AM »
I got a new engine gauge feed wiring harness as mine was cut up.  With the oil pressure gauge feed in place, where did Shelby install a oil pressure sender or was that left off?  My collection of engine photos doesn't give me indication of what is correct.
Logged

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9362
Re: 67 GT500 Oil Sender wire hook up
« Reply #1 on: September 02, 2015, 01:47:44 AM »
Quote from: supersnake on September 02, 2015, 01:30:15 AM
I got a new engine gauge feed wiring harness as mine was cut up.  With the oil pressure gauge feed in place, where did Shelby install a oil pressure sender or was that left off?  My collection of engine photos doesn't give me indication of what is correct.
The 67 Shelby had a mechanical oil pressure gauge only. The oil going through nylon tube feeds the mechanical oil pressure gauge. Since the idiot light was not used , the electric oil sender wire was snipped where it leaves the wrapped gauge feed harness.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline supersnake

  • Newbie
  • *
  • Posts: 26
Re: 67 GT500 Oil Sender wire hook up
« Reply #2 on: September 03, 2015, 01:31:31 AM »
Perfect!  Thanks.
Logged
Pages: [1]   Go Up
« previous next »