Topic: Drilling Emblem and Antenna Holes. Template?

[GT500KR]

Hey Guys,

 I'm wondering if there is a template out there anywhere that would help in drilling the emblem holes, or at least showing the proper location for the "289", "Mustang" and Tri-Bar/Horse emblems on a 64 1/2 Mustang. I'm using NOS Fenders and Emblems. My originals are long gone, so I have nothing to reference. I would like to do the drilling before paint.

 I also need same for the radio antenna.

Thanks, Charlie.

[kutzoh]

Charlie-
    Short of using an original to take measurements from, here's an article from MM addressing placement:

http://www.mustangmonthly.com/howto/mump_0105_how_to_pin_letters_on_a_1965_1968_mustang/

There was a web site with the template for the antenna but the site was taken down, hopefully someone saved it and it will surface.

Hope this helps,
Greg

[GT500KR]

Thanks Greg, that helps a lot!

[kutzoh]

Found the template- (scroll down about half way)

http://web.archive.org/web/20111231142033/http://www.hammar.dyndns.org/~djhamma/options.htm

Greg

[J_Speegle]

Found the template- (scroll down about half way)

http://web.archive.org/web/20111231142033/http://www.hammar.dyndns.org/~djhamma/options.htm

Did you try and click on the link for the pattern ??

Dave's site has been down for a while and it does not appear that the site that archived it did so for the links also

[JKWilson]

I saved the template from Dave's website. It was posted several months back in response to another forum member looking for the same thing.

http://www.concoursmustang.com/forum/index.php?topic=6133.msg37792#msg37792

[CW4macret]

Went and took a few pictures of my original fenders off my D code hope this helps.

[GT500KR]

Thanks CW, JK, J and kutzoh. It's going to be hard to start drilling those NOS fenders, but I feel like I can proceed thanks to your help.