« previous next »
Pages: [1]   Go Down

Author Topic: Hood inner wing rubber bumpers - which way around?  (Read 1145 times)

Offline 2V8s

  • Newbie
  • *
  • Posts: 31
Hood inner wing rubber bumpers - which way around?
« on: February 04, 2011, 12:00:22 PM »
Hi,

stupidly I removed my old ones and didnt note which way around they were! I have new ones to fit, and the front pair have one side with a ribbed finish where the other side is ssmooth.

These are the two butterfly shaped rubbers towards the front of each inner fender that the hood rests on.

Does anyone know if the ribbed side should be towards the engine bay (and visible) or towards the fender?

Thanks
Logged
1967 Mustang Convertible C code auto - San Jose 30th Jan 1967
1974 Corvette convertible 350 L48 Auto
2004 Mg ZT 260 SE (Ford V8)
1994 Rover 214 Si 16v
2005 Renault Grand Espace 2.2 DCi

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7687
Re: Hood inner wing rubber bumpers - which way around?
« Reply #1 on: February 04, 2011, 12:41:06 PM »
Seen a lot of cars either way, but when I restore a car and don't know how they were on that particular car, I put the ribbed side to the fender.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline gtamustang

  • CPM
  • Global Moderator
  • Sr. Member
  • ****
  • Posts: 297
Re: Hood inner wing rubber bumpers - which way around?
« Reply #2 on: February 04, 2011, 02:59:47 PM »
+1

Regards,
Pete Morgan
Logged
Pages: [1]   Go Up
« previous next »