« previous next »
Pages: [1]   Go Down

Author Topic: Accelerator cable removal  (Read 582 times)

Offline Hipo giddyup

  • Hero Member
  • *****
  • Posts: 1207
  • There is no end to doing right. Giddyup!!!
Accelerator cable removal
« on: December 09, 2020, 01:05:38 PM »
I have everything cleared from the firewall to start out metal work on the 70'. Only thing left is the accelerator cable and a plastic retainer that I cannot figure out how to remove. Is there a special way to removal the retainer from the firewall?
Logged
1967 Springtime Yellow Coupe, 289 2v 3spd, Metuchen built, Nov. 17th 66'
1966 Sahara Beige Coupe, 289 2v 3spd, Dearborn built, July 21st 66'
1964 1/2 Pagoda Green Coupe, 260 2v 3spd, Dearborn built, June 30th 64'
1966 GT350 Fastback clone, 289 HiPo, 725cfm Holley, 4spd, SanJose built, Nov 25th 65'

Offline cobrajet_carl

  • Sr. Member
  • ****
  • Posts: 363
Re: Accelerator cable removal
« Reply #1 on: December 09, 2020, 04:03:45 PM »
From the inside, squeeze the four tabs in and push it through the firewall.
Logged
Carl
70 and 71 Dearborn mach Is

Offline Hipo giddyup

  • Hero Member
  • *****
  • Posts: 1207
  • There is no end to doing right. Giddyup!!!
Re: Accelerator cable removal
« Reply #2 on: December 10, 2020, 10:22:44 AM »
Thank you Carl! I will give it a go.
Logged
1967 Springtime Yellow Coupe, 289 2v 3spd, Metuchen built, Nov. 17th 66'
1966 Sahara Beige Coupe, 289 2v 3spd, Dearborn built, July 21st 66'
1964 1/2 Pagoda Green Coupe, 260 2v 3spd, Dearborn built, June 30th 64'
1966 GT350 Fastback clone, 289 HiPo, 725cfm Holley, 4spd, SanJose built, Nov 25th 65'
Pages: [1]   Go Up
« previous next »