Topic: 67 fastback side molding installation

[67gta289]

I'm getting near the point where I'll be reinstalling the drip rail molding, and if I recall correctly there was (and the body assy manual indicates that there should be) a rubberized seal/gasket between 517A10 and the body.  Something along the lines of 0.88" wide by 1/8" thick.  I don't see one at my go-to NPD.  The MPC picture attached does not show it.

Am I right about this, and if so does anyone know of a source?

[Bossbill]

Am I right about this, and if so does anyone know of a source?

Yes and no.

[67gtasanjose]

I'm getting near the point where I'll be reinstalling the drip rail molding, and if I recall correctly there was (and the body assy manual indicates that there should be) a rubberized seal/gasket between 517A10 and the body.  Something along the lines of 0.88" wide by 1/8" thick.  I don't see one at my go-to NPD.  The MPC picture attached does not show it.

Am I right about this, and if so does anyone know of a source?

Yes, and I found some for my project a while ago...Let me try and remember where I bought it...

[67gtasanjose]

I am not sure I bought mine here right now but: http://www.virginiaclassicmustang.com/65-73-MUSTANG-ROOF-RAIL-WEATHERSTRIP-RETAINER-CHANNEL-TO-BODY-SEAL-12-FOOT-ROLL-P408282.aspx

[J_Speegle]

I've used the thin 3M black foam tape. Sometimes have to install two strips side by side to reproduce at least the area width. Not seen once installed

Believe there are a number of threads that discuss it in the 69 section for those over the window trim pieces

Some threads that might help a little

http://www.concoursmustang.com/forum/index.php?topic=3155.msg16899#msg16899

http://www.concoursmustang.com/forum/index.php?topic=17484.msg110203#msg110203

http://www.concoursmustang.com/forum/index.php?topic=4084.msg22512#msg22512

Hope this helps

[67gta289]

Excellent!  Thanks for the replies. John