Topic: '66 289 a/c compressor mounting bolts

[socalgt]

Other than wishing I didn't have the power steering pump installed......any one have a "trick" for installing the 4 mounting bolts to the bottom of the compressor.....can't really see how to get in there.

                                                                                                           Thanks!

                                                                                               

[Bob Gaines]

Other than wishing I didn't have the power steering pump installed......any one have a "trick" for installing the 4 mounting bolts to the bottom of the compressor.....can't really see how to get in there.

                                                                                                           Thanks!

                                                                                               

Take the bracket off and install the compressor/bolts and re install both as a unit. Sorry that is how I always have done it .

[J_Speegle]

Other than using numerous tools, swivels and banging knuckles allot Bob's method has its benefits in my experience

[ChrisV289]

I've used ratcheting wrenches to get under there but have to be careful not to scratch the pump on the back bolts

[socalgt]

Thanks for the replies....sounds like there's no easy way.....(what a surprise)....to do this....hate to remove the mounting bracket just to put it back...but I see your point.

[CharlesTurner]

The setup is designed for easy install with the compressor mounted to the bracket.  There should be 3 studs already installed on the motor.  With the compressor mounted to the bracket, just slide the bracket over the studs, then use a ratchet with a long extension through the holes of the p/s bracket to tighten the locking nuts. 

[socalgt]

Almost gave up....managed to install them after loosening the p.s. mounting bracket.....not easy...as you say, they must have been joined before installation at the factory.

                                                                                                      Thanks....