« previous next »
Pages: 1 [2]   Go Down

Author Topic: Brake drum finish  (Read 4140 times)

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24623
Re: Brake drum finish
« Reply #15 on: April 19, 2020, 07:07:30 PM »
Style of drum is going to vary depending on application and supplier

Here are some original service pieces that have been posted earlier and some new ones, that show finish and contrast as well as untreated/messed with cast surfaces

Hope they help













Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline Bossbill

  • Hero Member
  • *****
  • Posts: 3283
  • In the middle of project hell
Re: Brake drum finish
« Reply #16 on: April 19, 2020, 10:02:49 PM »
That's a fair bit darker than I thought.

Do you have any of the rear drums? I'm interested in the bolt up surface.

Thanks again!
Logged
Bill
Concours  Actual Ford Build 3/2/67 GT350 01375
Driven      6/6/70 0T02G160xxx Boss 302
Modified   5/18/65 5F09A728xxx Boss 347 Terminator-X 8-Stack
Race        65 2+2 Coupe conversion

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24623
Re: Brake drum finish
« Reply #17 on: April 19, 2020, 11:09:49 PM »
Will look for some rear drum examples Only the bottom picture has one on a Shelby from 65 at the SA factory (top right corner) Slightly darker face might suggest its been blacked out but not a great picture for this detail
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline ng8264723

  • Newbie
  • *
  • Posts: 49
Re: Brake drum finish
« Reply #18 on: April 22, 2020, 09:42:55 PM »
Southern polyurethane primer works awesome on a black.  IT should be fine on drums a swell.  They don;t get over 200.  Then use a rattle can for the top coat..............
Logged
Pages: 1 [2]   Go Up
« previous next »