« previous next »
Pages: [1]   Go Down

Author Topic: 289 intake bolt washers  (Read 826 times)

Offline 7R02A

  • Full Member
  • ***
  • Posts: 107
289 intake bolt washers
« on: October 18, 2016, 05:48:50 PM »
All, I am curious what is the correct washers to use on a '67 289 intake manifold bolt.   My originals appear to have an aluminum washer.  NPD sells a rubber coated washer.  Which is correct?  Car details in signature.
Thanks
John
Logged
John
1967 Fastback, A code, automatic transmission, Deluxe interior, AC, PS, P disc brakes, tilt, consoles, exterior group, fold down, DSO 71.
San Jose build, Actual build: Dec 17, 66.

Offline Scott302

  • Full Member
  • ***
  • Posts: 164
Re: 289 intake bolt washers
« Reply #1 on: October 18, 2016, 07:02:18 PM »
John,
The original washers were "rubber" coated aluminum to seal the few bolt holes that are open to the water passages.  The coating on yours has worn off over time and use.  It doesn't take much to separate the rubber and I doubt they were ever intended to be used more than once.
The washers we have are US-made by the original supplier to Ford.
Regards,
Scott
Logged
Scott Halseth
Ford Product Manager
National Parts Depot
MCA#01776

Offline 7R02A

  • Full Member
  • ***
  • Posts: 107
Re: 289 intake bolt washers
« Reply #2 on: October 18, 2016, 07:06:00 PM »
Thank you Scott.  That's what I needed to know.
John
Logged
John
1967 Fastback, A code, automatic transmission, Deluxe interior, AC, PS, P disc brakes, tilt, consoles, exterior group, fold down, DSO 71.
San Jose build, Actual build: Dec 17, 66.

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7346
Re: 289 intake bolt washers
« Reply #3 on: October 18, 2016, 08:16:55 PM »
And the washers are Ford part number - 379257-S100.
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.
Pages: [1]   Go Up
« previous next »