Topic: Replacing tubular rivets in 66 grille

[sgl66]

I need to replace 2 rivets. I have the correct tubular style, what are people using to crimp them?

[jwc66k]

I use one of these, bought back when it wasn't as expensive. You also need two dies, one domed for the top of the rivet, one with a "pin" for the bottom.
http://rivetsonline.com/to-to-888-15.html
http://www.rivetsinstock.com/
Jim

[sgl66]

Thanks Jim,

I'm only doing 2 rivets so looking for a way to MacGyver it if possible

[67gtasanjose]

I made this tool for installing tubular rivets on my 67 Mustang Grille.
Same tool will work on your 66.

Use a 3/16 steel ball-bearing under the die attached to the threaded shaft to prevent the die from spinning. The tool works great.

[sgl66]

Thanks for the pictures. I heading down a similar path.