ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1971 - 1973 => Topic started by: rcg301 on December 16, 2013, 10:14:53 PM

Title: 73 honey comb hole template
Post by: rcg301 on December 16, 2013, 10:14:53 PM

I have a 1973 Mach 1 that had to have the rear tail light panel replaced the new tail light panel.  The new panel does not have the holes for the honey comb plastic trim.   Does anyone know where I can find a template of where the holes are suppose to go?  any help is appreciated. thanks again.

Title: Re: 73 honey comb hole template
Post by: nham3407 on December 17, 2013, 09:32:21 AM

A couple of months ago I could have made a template before I installed mine.  The trim pieces for the top and bottom of the honeycomb panel have indentations where the clips are placed.  If you use those as a guide you can match them up.  Here is a photo of my car you can reference against to get you in the right areas.

Title: Re: 73 honey comb hole template
Post by: rcg301 on December 18, 2013, 08:42:09 PM

Thanks, will do!