ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1964 1/2 - 1965 => Topic started by: Armond on March 24, 2025, 06:59:42 PM

Title: 65 Fastback Trunk Measurement
Post by: Armond on March 24, 2025, 06:59:42 PM

I need a measurement, note picture, from the back of the trunk divider to the center of the hole on a fastback.  I am putting a 65 back together that had been cut up for racing etc. I just want to make sure this is correct before I start to weld it back together, any help appreciated, thank you!

Title: Re: 65 Fastback Trunk Measurement
Post by: Bossbill on March 24, 2025, 07:49:41 PM

 I have 19 1/4 to the edge on both sides of my 65 street car. 19 5/8 to center (approx).

Title: Re: 65 Fastback Trunk Measurement
Post by: Armond on March 24, 2025, 07:55:22 PM

Thank you so much Bill

Title: Re: 65 Fastback Trunk Measurement
Post by: Bossbill on March 24, 2025, 08:04:25 PM

You bet.
Oh, I should note I was using a tape with an L on the end. Be sure to use a similar contractor tape measure.

Title: Re: 65 Fastback Trunk Measurement
Post by: Armond on March 25, 2025, 03:02:56 AM

Thank you!