ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1966 Mustang => Topic started by: KenFirch on July 29, 2019, 03:40:05 PM

Title: Shock Tower Hole Question - 66 SJ
Post by: KenFirch on July 29, 2019, 03:40:05 PM

I'm filling up a few holes before painting the engine bay, from alarms, etc.  On the drivers side shock tower there's a hole that I'm not sure of.   Is it a factory hole?

On a 66 SJ Convert.
 
Thanks!

Title: Re: Shock Tower Hole
Post by: jwc66k on July 29, 2019, 04:50:13 PM

It's not factory. Weld it over. It's looks to be in an odd place to grease the upper "A" arm shaft, which was semi-common.
Jim

Title: Re: Shock Tower Hole
Post by: KenFirch on July 29, 2019, 05:43:48 PM

Done!  I vaguely remember one of those old horns for the alarm being there years ago, but wasn't sure.

Thanks

Title: Re: Shock Tower Hole
Post by: ChrisV289 on July 29, 2019, 05:54:16 PM

Did the car have AC? Would be where the bracket goes to secure one of the lines

Title: Re: Shock Tower Hole Question - 66 SJ
Post by: KenFirch on July 29, 2019, 08:00:57 PM

Arghh!  Yes, it is an AC car.  Getting my drill.  LOL.