« previous next »
Pages: [1]   Go Down

Author Topic: Console Wiring Clips  (Read 848 times)

Offline SunnDogg

  • Newbie
  • *
  • Posts: 8
Console Wiring Clips
« on: January 10, 2019, 07:00:04 PM »
Has anyone found a vendor or have a part number for the wiring loom clips that are used (4) on the floor console? Picture of said clip attached. Thanks in advance.
Logged

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7344
Re: Console Wiring Clips
« Reply #1 on: January 10, 2019, 08:16:53 PM »
If I may direct your attention to this forum's library section under topic "Mustang Hardware Spreadsheets 69-70" where you will find two spreadsheet files, one by part number and the other by application. Under application, "Wiring Harn, Console, Center-Console", you will find part of your answer.
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24612
Re: Console Wiring Clips
« Reply #2 on: January 10, 2019, 10:49:57 PM »
Don't believe they are reproduced and will be difficult to find ( I would guess) as NOS)

Likely a used part that you'll need to get from a donor 
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline SunnDogg

  • Newbie
  • *
  • Posts: 8
Re: Console Wiring Clips
« Reply #3 on: January 11, 2019, 01:15:31 PM »
Thank you, both. Was not aware of the spreadsheet in the library. Appreciate the help.
Logged

Offline 7Lscjracer

  • Hero Member
  • *****
  • Posts: 521
Re: Console Wiring Clips
« Reply #4 on: January 15, 2019, 09:18:48 PM »
What size are the clips you need and full or partial loop?
Logged
69 Mach 1 San Jose Nov. 68 build
Bought May '81, sold Sept '20
Pages: [1]   Go Up
« previous next »